DELTA-THENE horizontal

Application

Cover corners, edges, valleys, etc. with cuttings of DELTA®-THENE. Outdoors, strips should be run up the wall to a height of at least 15cm.

Begin by putting the inlet in position. Cover it with a 60-cm square DELTA®-THENE cutting. Make criss-cross cuts across the inlet, mould down, and fasten.

Cover the junction between the floor and the masonry with a strip no less than 30cm wide.

Always start laying out the sheets from the lowest point, either with or across the gradient.

The covering strip at the edge of the sheet must be removed to permit the sealing compound below to bond to the overlap of the adjacent sheet.

Finish all overlaps very carefully with a pressure roller.

Material

A combination of special cross-laminated
HDPE film and a sealing / adhesive
layer made of bitumen rubber.

Properties

• In horizontal waterproofing applications, DELTA®-THENE can be applied at least 50 % faster than conventional welded bituminous sheets.
• No torch is required, and connections between the material and plastic windows or doors are unproblematic.
• Any damage caused in the DELTA®-THENE layer by subsequent activities may be easily repaired by gluing on a patch.

Technical data

Accessories

DELTA-BAND
(TAPE)

DELTA-
THENE
GRUNDANSTRICH

DELTA-
THENE
KÄLTEGRUND-
ANSTRICH

DELTA-
THENE Band T300

Downloads

Product Information

Installation Information