DELTA-MS sub-base course

Application

On a leveled and stable base the roles DELTA ®-MS layer could simply rolled out.

Longitudinally and transversely, the single roles should overlap at least 20 cm. To reduce overlap losses, we recommend using wide rolls.

For the lower reinforcement strip-shaped spacers are necessary.

Between the upper and lower reinforcement to special spacers be used.

Material

Studded membrane made of special, high-density polyethylene.

Properties

• When using DELTA-MS as a sub-base course, you apply crucial advantages straight from the roll: high compressive strength, minimum installation time, no equipment cost, no additional excavation, no waiting period, additional protection of the floor slab from rising damp, and grout loss is effectively prevented from leaching downward. DELTA-MS resists acids, alkalines, oils, and solvents. Its toughness and stiffness enables the dimpled sheet to bear the weight ofpeople and wheelbarrows, and it will safely carry the strip-shaped reinforcement mesh spacers.

Technical data

Accessories

No accessories necessary

Downloads

Product Information