Choose your country

DELTA® protects property.
Saves energy. Creates comfort.

Dörken GmbH & Co. KG
Wetterstraße 58
D-58313 Herdecke
Tel.: +49 23 30/63-0
Fax: +49 23 30/63-355
bvf@doerken.de

© Dörken GmbH & Co. KG.
A Dörken Group Company

DELTA-PT

zoom

Referenz

Application

Install DELTA®-PT vertically. Use plugs to fix DELTA®-PT-PROFIL strips to the upper and lower sheet edges. Fixing plugs should be spaced approx. 25 cm apart both horizontally and vertically. Start in the centre of each sheet and work towards the sides.

Sheets should overlap by approx. 20 cm along the mesh-free edge. There should be no bridges between the plaster and the damp cellar wall. Reinforce and seal butt joints in corners.

Plaster should be trowel applied in two coats. Do not apply the second coat before the first has initially set.

Do not use DELTA®-PT-PROFIL with plasterboard panels. To enable the moisture-laden air to circulate, leave a gap 1 cm wide below the ceiling and above the floor.

Material

Special, high-density PE and HDPE gauze.

Properties

Ventilated dimpled membrane incorporating a bonded mesh. Guaranteed against degradation for 25 years.
DELTA-PT is extremely reliable, with mesh welded to the dimpled sheet to prevent delaminating.
Creates a ventilation air gap between damp cellar walls and new plaster coats with its 8-mm dimples.

Technical data

Roll size	2,0 x 20,0 m
Pressure resistance	approx. 70kN/m²
Air volume for the rear ventilation	approx. 5.5 l/m²
Weight	approx. 530g/m²
Stud height	approx. 8mm
Membrane overlap	approx. 20cm
Material usage	Per m² of wall: DELTA-PT approx. 1.15m² DELTA-PT PROFILE SECTION approx. 1m DELTA-PT NAIL PLUGS approx. 15.